![]() ![]() Using the power probe of your multimeter to check terminal A and B while grounding on the transmission should net you a solid resistance reading. ![]() Take your voltmeter and measure the resistance at terminal A and terminal B of your Honda Civic Shift solenoid connector by using the chassis ground. With your Honda Civic shift solenoid connector unplugged, you can now being our How To test a Honda Civic Shift solenoid guide. Then depress the connector clip to pull apart this shift solenoid harness. Here you see the two wire shift solenoid connector, pull up on the back of this unit and depress the clip to pull this connector off.Īfter pulling up on this bracket and depressing the clip, you can pull off this entire wiring harness as a whole. To access the wiring connectors to your Honda Civic shift solenoid however, you must first unplug your upstream oxygen sensor and your coolant temperature sender.ĭisconnect your upstream 02 sensor connector, shown here and move it to the side so you can gain room.ĭisconnect the temp sender here to give you access to the rear 10mm bolt that holds the Honda Civic Shift solenoid on. ![]() The first of which includes testing the resistance between the terminals on your shift solenoid connector, and the other is sending power to the solenoids themselves.įirst locate your shift solenoids, which should be under the front radiator hose mounted near the headers on your 1996-2000 Honda Civic SOHC. There are two specific tests we will be using to test both shift solenoids in your Honda Civic. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |